How to Choose a Heat Pump Installer: Questions to Ask
A checklist for finding and vetting a heat pump contractor, comparing quotes, and avoiding common installation mistakes.
Installation quality has as much effect on comfort, efficiency and lifespan as the equipment itself. Use this checklist to find a contractor you can trust.
Where to look
- Our installer directory, filtered by your state.
- Your utility's or state program's list of participating contractors. Some rebates require them.
- Manufacturer dealer locators. Many brands have "elite" or "diamond" dealer tiers with extra training and longer warranties.
- Neighbors and local community groups who've had heat pumps installed recently.
Questions to ask every contractor
- Will you do a room-by-room load calculation (Manual J or equivalent)? Sizing by square footage or by copying the old system's size is a red flag.
- How did you choose this capacity, and what is its output at our design temperature?
- Will you inspect, test or seal the ductwork? (for ducted systems)
- What backup heat, if any, do you recommend, and how will it be controlled?
- Is my electrical panel adequate? Who handles permits and electrical work?
- Which rebates and incentives does this system qualify for, and will you handle the paperwork? Ask for the AHRI certificate number.
- Are you licensed and insured in this state, and how many heat pumps have you installed in the past year?
- What warranties apply, on both the equipment and your labor, and does the equipment warranty require registration?
Comparing quotes
Get at least three written quotes. A good quote lists the exact model numbers of the outdoor and indoor units, capacity, efficiency ratings, scope of duct and electrical work, line-set and mounting details, condensate drainage, permits, start-up and commissioning, and warranty terms. The cheapest quote often leaves out work that someone will have to pay for later.
Red flags
- No load calculation, or sizing based only on square footage.
- Pressure to sign the same day.
- Claims that a heat pump "doesn't work" in your climate without any analysis, or, on the other side, promises of guaranteed savings with no look at your bills.
- Reluctance to put model numbers and scope in writing.
After installation
Ask the installer to walk you through the thermostat or remote settings, filter location, and maintenance schedule. Keep the commissioning report and AHRI certificate with your rebate paperwork. Then read our maintenance guide.
This guide is general information, not professional advice. Every building is different; get a load calculation and written quotes from licensed contractors before deciding. Spotted an error? Let us know.