Types of Heat Pumps: Air-Source, Ductless, Geothermal and More
Compare ducted and ductless air-source heat pumps, geothermal systems, air-to-water units, dual-fuel setups and heat pump water heaters.
"Heat pump" covers a family of technologies. They share the same refrigeration cycle but differ in where they get heat from and how they deliver it. Here is how the main types compare.
Ducted air-source heat pumps
The most common type in North American homes. An outdoor unit pairs with an indoor air handler and uses existing ductwork, much like central air conditioning. It's a natural choice when you already have ducts in good condition, especially when replacing a central AC and furnace together.
Watch for: leaky or undersized ducts, which waste energy and can cause comfort complaints. Have ducts inspected as part of any quote.
Ductless mini-split heat pumps
An outdoor unit connects to one or more indoor "heads" mounted on walls, ceilings or floors. Each head serves a zone with its own control. Mini-splits suit homes without ducts (homes heated by boilers or baseboards), additions, finished basements and garages, and rooms that are always too hot or too cold.
Watch for: one large outdoor unit with many small heads isn't always better than a few right-sized systems. Ask your installer how they sized each zone.
Ground-source (geothermal) heat pumps
These systems exchange heat with the ground through buried loops of pipe. Because ground temperature stays fairly steady year-round, geothermal systems are very efficient and largely unaffected by cold snaps. The loops last for decades.
Watch for: drilling or trenching makes installation more expensive and site-dependent. Geothermal tends to make the most sense in new construction, on larger lots, or where incentives are generous.
Air-to-water heat pumps
Instead of heating air, these units heat water for radiant floors, low-temperature radiators or fan coils, and many can also produce domestic hot water. They are common in Europe and growing in North America, especially as boiler replacements.
Watch for: existing radiators may need upgrading, because heat pumps are most efficient at lower water temperatures than a typical boiler.
Dual-fuel (hybrid) systems
A heat pump paired with an existing or new gas, propane or oil furnace. The heat pump handles most of the year and the furnace takes over in the coldest weather, or whenever it's cheaper to run. This can be a practical step for very cold climates or homes with a newer furnace.
Heat pump water heaters
A tank water heater with a small heat pump on top that pulls heat from the surrounding air. These typically use a fraction of the electricity of a standard electric tank. They work best in spaces that stay above roughly 40-50°F, such as basements, garages in mild climates or utility rooms, and they cool and dehumidify the space they're in.
Commercial systems
Larger buildings use variable refrigerant flow (VRF), packaged rooftop heat pumps, water-source loops and heat pump chillers. See our commercial heat pump guide.
Quick comparison
| Type | Best for | Main trade-off |
|---|---|---|
| Ducted air-source | Homes with good existing ducts | Duct losses if ducts are poor |
| Ductless mini-split | Homes without ducts, additions, problem rooms | Indoor heads are visible; needs careful zoning |
| Geothermal | New builds, larger lots, long ownership | Higher upfront cost for loops |
| Air-to-water | Replacing boilers, radiant floors | May need emitter upgrades |
| Dual-fuel | Very cold climates, newer furnace on site | Still uses fossil fuel on the coldest days |
| Heat pump water heater | Replacing electric or gas tank heaters | Needs space, airflow and a condensate drain |
This guide is general information, not professional advice. Every building is different; get a load calculation and written quotes from licensed contractors before deciding. Spotted an error? Let us know.